I'm trying to baseline my equipment while getting the hang of everything. My grinding setup I'm rather proud of. Using a power drill cut my grinding time down to about 15% of what is was by hand.
https://www.dropbox.com/s/zr5fc196h07ln ... .53.34.jpg
Yesterday I was just grinding away in this ridiculous September heat like an evil sweaty witch in my kitchen.
It was a double, too.
- Posts: 301
- Joined: 3 years ago
- Favourite Beer: IPA
- Location: Hanwell, New Brunswick (just outside of Fredericton)
Victorio Deluxe Grain Mill
First batch I did only had 2lbs of grain, however what a PITA to keep turning. They make a motor for it, but it is another $40. So I found a little 3" Straight blade screw driver that came out of a vehicle I no longer have, cut off the blade, squared the end so it would chuck into a drill without slipping and viola. Now the issue is that the screw driver bit is stuck in the mill now. Not really an issue, as I can't see me ever wanting to hand crank it every again. Just have to make the the drill is charged for brew day.
Warthaug wrote:First thing I've done to all my mills is pull the handle...you won't miss it.
Made the mistake of not pulling mine off. Now it wont come off!
Tap 3: Cheaters Red Ale
Who is online
Users browsing this forum: No registered users and 7 guests