Page 1 of 1

Draft build, advice needed.

Posted: |02 Mar 2015|, 13:36
by Three sheets
So I'm playing with the idea of building a small 2-3 tap draft system and I'm looking for some ideas, possible sources for supplies and a rough cost estimate. I'm trying to build it as cost effectively as possible.

Which is better, ball or pinlock? What is the best source online for regs, kegs, and taps, and where is the best place to get gas and a tank?

As for chilling, I'm still not sure if I'm going to go with a keezer or modified refrigerator. Still not sure where to put this thing as space in my house is limited.

Re: Draft build, advice needed.

Posted: |02 Mar 2015|, 16:36
by SeanGodd
Where are you located?

Re: Draft build, advice needed.

Posted: |02 Mar 2015|, 19:57
by Three sheets
I'm on Vancouver island

Re: Draft build, advice needed.

Posted: |02 Mar 2015|, 20:44
by SeanGodd
Three sheets wrote:I'm on Vancouver island
Ah...I can't help ya then. I have some rear closing chrome taps Im Going to be selling as well as a cheap Chinese regulator and an assortment of peices. Most I got for dirt cheap. But alas I am in ottawa

ontario beer kegs is a good place ad well as everwood brew shop. Both are on the other side of cabana. Everwood has some good shipping rates.

Hope that helps ya

Re: Draft build, advice needed.

Posted: |02 Mar 2015|, 22:31
by Three sheets
Yeah, obk looks pretty competitive. And thanks anyways.

Re: Draft build, advice needed.

Posted: |07 Mar 2015|, 12:44
by jason1973
Three sheets wrote:I'm on Vancouver island
too bad your not in toronto, i know where to get used dandby 4.4's for $50, not sure if there all fridge or not will be checking next week, need one for lager cabinet.