Small project to automate my 120V RIMS

Why buy your homebrewing equipment if you can make it? Share completed DIY projects and future plans and ideas alike!
acsummer
Newbie
Posts: 2
Joined: 1 month ago
Favourite Beer: Red Racer IPA

Small project to automate my 120V RIMS

Post #1 by acsummer » 1 month ago

Hi All!!

I am a new member to the board. I love DIY projects and all grain brewing definitely enables my passion.

Long have I used a Tri Clamp RIMS setup with a 120V ULWD element in congunction with an analog thermometer. This past month I decided to utilize the an Inkbird controller to automate the mash temp.

With several 1.5" end caps lying around I decided to drill a 3/8 inch hole to accommodate an inexpensive weld-less thermo-well from my local home brew shop. This would not be an easy task as many will report that stainless steel is very hard to cut through. Patience, two drill batteries, WD40 and a professional grade step bit I was able to cut a hole (although just a bit off center).

IMG_0057.JPG


End result
IMG_0058.JPG


Ready to dry fit the weld-less thermo-well
IMG_0059.JPG


Assembled and ready for a leak test
IMG_0060.JPG


Clamped into the RIMS ready for action
IMG_0063.JPG


After running the PID to raise the water from 55 F to 155 F (4 hours) there were no leaks at all.

I will share pics of the next brew day with the RIMS in action.
Fermenting - Kona Coco Brown Ale clone
Fermenting - Four Winds IPA clone
Tap 1 - Chocolate Cookie Brown Ale
Tap 2 - Soda Water
Tap 3 - Rootbeer
User avatar
brhenrio
Posts: 332
Joined: 2 years ago
Favourite Beer: Stouts
Location: Bonnyville, Ab

Re: Small project to automate my 120V RIMS

Post #2 by brhenrio » 1 month ago

Neat idea. When i punched holes in my kettle i used tapping fluid and a stepbit followed by a radio punch. The stepbit was specifically for SS. Still was a PITA.
In the fermentor: Gentlemans Skids Brown Ale
Tap 1: toy soldier stout
Tap 2: A Boy Named Sue's Root Beer
Tap 3: Cheaters Red Ale
acsummer
Newbie
Posts: 2
Joined: 1 month ago
Favourite Beer: Red Racer IPA

Re: Small project to automate my 120V RIMS

Post #3 by acsummer » 1 month ago

Thanks brhenrio, cutting through the 5mm stainless was by far the hardest on my step bit to date :)
Fermenting - Kona Coco Brown Ale clone
Fermenting - Four Winds IPA clone
Tap 1 - Chocolate Cookie Brown Ale
Tap 2 - Soda Water
Tap 3 - Rootbeer

Return to “DIY Projects”

Who is online

Users browsing this forum: No registered users and 5 guests